I have a DJI Phantom Vision 2+ drone.

I have completed a few dozen flights with no problems except the odd bad landing.

On my last flight I realised my horizon is no longer level, it’s out by 3.55 degrees from horizontal.

Most likely caused after my last heavy landing.

Is it possible to reset the camera to the horizontal position myself or should it be sent back to the distributer.

I am hoping there is an answer in here soon, cause I have the SAME issue =) But DAM if we dont LOVE THIS DRONE! Even with the crash...it held up better than I thought it would.

There are many videos on YouTube of people fixing the issue, here is just one of them....
http://youtu.be/SFxM8OOWRQc
Not had to do it myself, but it looks simple enough.

Thanks John, was HOPING there was a calibration fix. Guess I will try RMA 1st. if not, that video was pretty good. Thanks again.

Thank you John. that video helps a lot.

jaynlindz Posted at 2014-10-10 15:53
Thanks John, was HOPING there was a calibration fix. Guess I will try RMA 1st. if not, that video wa ...

Hi Jay, you can try a IMU calibration, if the problem still existed, suggest you to send it back for repair and check.

DJI-Sophie Posted at 2014-10-13 17:36
Hi Jay, you can try a IMU calibration, if the problem still existed, suggest you to send it back f ...

I let err roll & didnt mess with it, but NOW...ummm, I had a bad crash & am going to need to send it in I suppose. I am off on the X & Y axis  now. Also, camera went black. What do I need & need to know to get it in for repair?

johnwarr@live.c Posted at 2014-10-10 15:40
There are many videos on YouTube of people fixing the issue, here is just one of them....
http://you ...

It's a simple fix, I had to do it myself and took about 15 minutes to complete.

jaynlindz Posted at 2014-11-25 04:10
I let err roll & didnt mess with it, but NOW...ummm, I had a bad crash & am going to need to send i ...

Sorry to hear that... Please go to the link for our support center contact info: http://www.dji.com/support