hastings
New
United States
Offline
|
Finding my self a bit out of my league with the technologies and verbage, please bare with me.
So I've downloaded and installed the NAZA-M V2 Assistant software on my Mac. I am following videos tutorials from DSLRPros about claibrating. I'm using a Futaba T8FG controller. I'm noticing a couple of oddities between the Mac software and the PC version in the video. I asked DSLRPros and they weren't sure why things were different.
1st the Start/Finish Calibration buttons are different. There is only one set under Command Sticks Calibration and none under Sticks Monitor. This apparently is different the on the PC version of the software.
2nd
Under Aircraft,there is no way to test the motors. It appears that you can do this in the PC version of the Naza-M V2 Assistant software.
Ther are other concerns, ERROR 27 and ERROR 29 messages but I'll post those elsewhere on the forum.
thanks
Phil
|
|