Need a lil help or ideas.

Video looks like below and photos are messed up too.

Had a hard landing, replaced two props while onsite and took back off recording video and photos no issue.

Next day another job it worked fine and towards the end, video started looking like this and would just stop recording.

I have removed unplugged and re-seated gimbals cables.
Tried other known good SD cards
Reinstalled app
reapplied FW to drone and controller

Any ideas?

    << example of what it looks like when it does record.

Thanks for any guidance.
Rich

I would guess it is a torn ribbon cable....

HWCM Posted at 2017-5-2 22:50
I would guess it is a torn ribbon cable....

ya and likely inside... are guys fixing these them selves much yet?  i have had it two years so I could give it a go...

The video with the sheep only has those lines in the sky.  Could it be a setting on the camera?  I have seen that effect when people are adjusting the exposure.

DiverDan Posted at 2017-5-3 06:03
The video with the sheep only has those lines in the sky.  Could it be a setting on the camera?  I have seen that effect when people are adjusting the exposure.

No, that is not it.

dos this look like that on the sd card as well, or only on the phone?
I think there's a setting to show "overexposure zebra".. unlikely, but a slight possibility...  if that also shows on the sd card, it has to be either a bad cable somewhere or a faulty camera....
I used to have issues like this on some older camera I flew with, every time the ribbon cable inside the camera was lose or misaligned... it was often also accompanied by color fluctuations, sort of like with a monitor cable that's not quite in.....