Gimbal goes limp immediately after calibration  & then active again on osmo + . Is this normal ? Doesn't do this on my osmo (original).
See video link

Is it always happens to you? Or after the update?

Only after update

Don't think that's normal! What happens when you double click trigger to re-centre?

Salty777 Posted at 2017-5-23 07:44
Don't think that's normal! What happens when you double click trigger to re-centre?

Everything works as it should. Just this strange action at the end of the Auto Calibration.
The previous firm ware ver- gimbal holds level immediately after Auto calibration.
New firmware- gimbal goes limp at 99% - stays like this for 2secs- then holds level as normal thereafter.