Hi team.

I'm seeing an old problem back, and wondering if someone has a definitive fix. I had Assistant 2 v1.1.1 installed on my Win 10 laptop and successfully used it to install firmware onto my P4P. I like to re-calibrate VPS after each firmware installation, but when I select 'Calibrate', I get the usual splash screen for that but then a 'Frame Alignment Error' and I can't proceed. It then asks me to reboot the craft, which I do, but the error persists.

I uninstalled Assistant 2 v1.1.1, downloaded the latest v1.1.2, rebooted my PC and P4P, and ran Assistant again. Same error and I can't proceed with the calibration. Any ideas?

I saw the problem with v1.1.0 previously, but then the issue went away after a couple of re-installations. I'd like to think there's a better way to resolve this other than doing multiple uninstalls/re-installs...

Hi team.

I'm seeing an old problem back, and wondering if someone has a definitive fix. I had Assistant 2 v1.1.1 installed on my Win 10 laptop and successfully used it to install firmware onto my P4P. I like to re-calibrate VPS after each firmware installation, but when I select 'Calibrate', I get the usual splash screen for that but then a 'Frame Alignment Error' and I can't proceed. It then asks me to reboot the craft, which I do, but the error persists.

I uninstalled Assistant 2 v1.1.1, downloaded the latest v1.1.2, rebooted my PC and P4P, and ran Assistant again. Same error and I can't proceed with the calibration. Any ideas?

I saw the problem with v1.1.0 previously, but then the issue went away after a couple of re-installations. I'd like to think there's a better way to resolve this other than doing multiple uninstalls/re-installs...