Seems i have brick my rc done by an update failure. What can i do ?
No connection with dji assistant 2. No linking by Dji go and only the RC work.
White led fixed on RC...

May someone have an idea ?

Hi, I am sorry to read on your experience. However, the good news is that this is a quick fix. Try the following to see if this helps:

Turn on the controller, and the aircraft should be off.Press C1, C2, record and the wheel on the right side of the controller and then turn off the controller. Don’t let go of any fingers, and turn on the controller. Then the controller will be able to update again.

Let us know if that helps.

Hello, I also had a similar problem with the new firmware and the controller. After I update it says ¨air encoder error¨ and I don´t have video signal. I brought it down to the previous version and it was fine again, but tried to upgrade again with same problem. I don´t know what to do now.

Thanks but the issue is the same. Can't update again. DJI go say that the RC is connected but in about nothing else