Can I use LED module from NAZA M V2 or Wookong M on A2?

Also I ripped off a cable on my GPS module. Would it be a problem if I will solder it back togethter?
thank you.

Hi,
1. Each flight controller has it's individual LED unit and contain different functions. It's not recommended to mix them.
2. Before soldering please aware that thus will lose official warranty.

any ideas where i can purchase led module for a2?

http://www.uavproducts.com/index ... ;controller=product

on this page it says that
DJI WKM and/or A2 Bluetooth LED w/ USB


so, WKM and A2 using same LED module?

As far as I know they do share the same bt led. but I will let someone from dji confirm.

is there any place where I can purchase replacement cable for A2 GPS module?
it is just 2 pair shielded cable, as far as I see.

peterhusha Posted at 2014-12-19 06:46
on this page it says that
DJI WKM and/or A2 Bluetooth LED w/ USB

I bought WKM led. it is works just fine
thanks.

Hi

I ripped the cable of my A2 led module and purchased a new one. The new one blinks correctly but I can not get it to connect to my DJI Assistant app.
I have booted the drone many times and also reseted the BTU info with the A2 Assistant software and laptop many many times. Still I can't connect to the Assistant app.

Is it possible that the original LED is bound with the A2 and replacement ones don't connect to the Assistant app because of that? Or is my replacement LED faulty?

Tuukkuli Posted at 2016-11-24 09:41
Hi

I ripped the cable of my A2 led module and purchased a new one. The new one blinks correctly but ...

The original LED is not bound to the craft, so a replacement should be possible. It may be an issue with the LED port on the A2 itself. Are you able to try another A2 to see if the new LED works?