ValleyForge
lvl.3
Flight distance : 24754 ft
Australia
Offline
|
ValleyForge Posted at 1-23 02:42
I think I posted about this earlier - I have the same issue. I have tried several cables and now have a dedicated PD USBC cable from KondorBlue that should work. But it doesn't.
The motor does not remember calibration, even if left powered on by an external source.
And I have just repeated the lens calibration, the motor end points with USBC data cables AND the new beta firmware.
And it is exactly the same. I can get LiDAR controlled autofocus on the RS3Pro on C1 and tracking. But getting anything independent of the RS3Pro - whether you power down the RS3Pro, then change the connections, or don't; or connect the external power to the focus motor before disconnecting anything.
I don't think I am missing anything as I have followed the instructions exactly. Something isn't right. Over to you DJI Mods. |
|