robertklimmek
New
Brazil
Offline
|
Well guys, I have to tell you that the same occurred to me too
Every post I see, I feel more terrorized and hopeless...
I got My Osmo today. so... I turned it on, activated it, everything was working just fine. then I turned it off. not more than a minute later, I turned on again, and the gimbal made strange spins and tilts, and the motors kind of stuck and vibrating. the problem persisted the same way every time I turned it on then. so I was prompted by DJI Go app to update the firmware, and i've done it hoping that it would maybe "reset" gimbal parameters and everything would be just fine again. So after the firmware update 1.6.2.10 the gimbal was not doing that strange movements again, however, it was not working at all. on the app screen the message that the gimbal was locked appeared, but it was not locked, all three axis were UNLOCKED and after some sort of random tests, i've discovered that when the second axis is LOCKED the gimbal "thinks" that it is UNLOCKED, and tries to rotate, obviously with no success. so I tried everything, turn on, turn of, reupdate firmware, use Android, iOS, take gimbal out of the mount with the device on, with the device off, every sort of combinations... and nothing solved. the system simply "thinks" that when the second axis is LOCKED, the gimbal is UNLOCKED, and when second axis is UNLOCKED, it "thinks" it is LOCKED. so it's kind of a logic problem, maybe due to a software or even hardware.
I have a Phantom 3 and this product work just fine, perfectly. I hope not to lose faith on DJI, I always trusted on their products quality, but now I've seen so many cases of problems on the Osmo Product, and from a lot of people. Anyway, I will be changing the unit tomorrow for a new one, but with so many cases of problems, I'm feeling like the statistics is against me, and if I change the product, the new one will have a problem too |
|