eloynmarquez
New
Mexico
Offline
|
Hello fellow droners!
I have two Phantom 3 Pro sitting at my desk because this update (from DJI, android or Apple?). I had tried to update Firmware many times (logs files are successful for the drone, not for the RC), reinstall the App, tried the c1 + c2 + recording buttons at start and powering down the RC... nothing still. The gimbals move when I command from the RC but the drone lights are flashing yellow in one side and red in the other side.
After reading all posts, I noticed the USB tethering comment. My phone is a Asus Zenphone Z00AD with android version 5.0 and I noticed the USB option was OFF. I will try tomorrow this solution... I really hope it works, seems so simple but I have spend a lot of time figuring it out.
If it is such a common error, please relase a DJI help guide on the matter listted next to the documentation. Its OK to make mistakes, it is NOT OK to try to fix them.
Good night,
EDIT: No luck with the UBS tethering since the phone would not even recognize the RC as a compatible device, so the option stays gray and I cant force it to activate. I also tried updating the controller with the bin file inside the SD card inside the gimbal port, no luck. So I still have two Phantom 3 PRO sitting on the desk with video clients waiting. I will try to roll back all updates and start again.
EDIT2: Went back to roll FW to 1.3, but it is not possible after you updated to 1.7, I am tired of this S#$%, I am sending back the drone to DJI after spending about 6 days trying all what have been posted on the forums: roll back FW, tried two different phone, 4 UBS cables (one pristine, brand new), different PCs, different SD cards (from the two DJI drones that I have), tried to bind and reset RCs, discharge and recharge RC and batteries, leave the RC beeping for 30 mins, changed start-up order, etc, etc, etc, etc.... NOTHING WORKS. Thanks for the update DJI!!!
|
|