Donnie Stugots
First Officer
Flight distance : 3636782 ft
United States
Offline
|
Lidar Posted at 2017-1-2 08:10
While I'm not having the issue with the red props being too loose, I'm certainly having an issue with the white ones being too tight. They've gotten progressively tighter. The red ones are fine, but the white ones are almost impossible to remove without a pair of pliers. Any suggestions?
And Lidar you have the 1345T Props and locks correct ? These are the best in my Opinion . Be sure that you are pressing the Props firmly into the oblong fitting , then while placing firm pressure down, you turn the locks, and make sure they are snug against the base of the prop . I find it strange that 2 fit and 2 are tight . Are the props you have from DJI ? they could be out of tolerance if not.
I would replace these props and or locks, something sounds wrong and could snap in flight , can you take some pics as well ?
I replace my props and locks every couple of months, the locks are inexpensive insurance and the only thing I have seen snap and cause a crash .
Make sure you do that sooner than later, something sounds out of sorts for sure , better to play it safe .
donnie
|
|