Kmims
lvl.2
Flight distance : 51014 ft
United States
Offline
|
Hi all I'm a relativly new drone flyer thats been lurking on here for a couple of wks now.
I had been enjoying flawless operation and flights of my P4 untill today. After my last flight I installed the HDMI output module sourced from DJI. I also purchased a pair of FatShark Dominator V3 goggles to go along with the project. Upon booting up the controller w/DJI Go4 connected it prompted me to upgrade from v1.6.0 to v1.8.0 which I did without any problems. Rebooted again and all seemed fine, all systems are GO FOR TAKEOFF.
Bench test checkouts seemed fine and the video in the goggles was great. However on my first flight with the new parts I quickly noticed I was losing video sync often (200') from me and basicaly no longer had the range I used to have prior to all of this. During the flight I pulled the HDMI cable from the RC and all my problems were solved. It seems there's an RF coupling issue with the HDMI cable plugged in? possibly distorting the RF emission from the RC?
I found a few other post that seem to point the finger at the FW upgrade, but I'm not sure thats the case. What FW version does everyone else use with the HDMI module/goggles?
I was able to land the craft without any issues but am now stumped. Any input would be apprectaited.
My Setup:
Phantom 4
Ipad mini 4
FatShark Dom v3.
Latest version FW everything
Kelvin
|
|