Donnie *
First Officer
Flight distance : 3636782 ft
United States
Offline
|
You will want that VPS "enabled " for sure . If you try to use the switch on the RC toggle switch to lower the Gear does that work, this is the toggle next tothe RTH button ?
I would first check and make sure you are getting data from the VPS, this I believe on the Inspire 2 is on the bottom of the Go app and should give data from about 3 meters down to the ground , If this is NOT working the Aircraft does not Know it is near the ground and wont lower the gear , Keep in mind that in some cases you need to be very close to the ground for the auto landing gear to work , on my Inspire 1 I ned to be less than 1 foot off the ground for it to activate.
Perhaps you were not close enough to the ground to get it to activate ?
I dont own the Inspire 2 and maybe I am missing something , but I believe they work on the same principle . Maybe an Inspire 2 owner can chime in as well.
****What do yo mean by pressing the power button ? I believe this is only for going into travel mode on the Inspire 2 and you dont want to be doing touching that power button in flight if that is what you meant .
Pic below of location of VPS data on thr Inspire 1, I think the 2 has it in the same place but not 100% sure .
Good Luck
donnie
|
-
|