GoMe
 lvl.1
Germany
Offline
|
Hi,
I hope anyone can help me here. We have an Inspire 2 with a X5 Camera. We work on dual operator mode most of the time.
This worked perfect for the past flights.
Problem. Since the last flight I can't control the gimbal properly with the Slave Remote. When I rotate the Camera in yaw or pitch axis it goes back to center after 1 Second.
I first start the Drone with the Master Remote only. When I move the pitch axis of the gimbal on the Master Remote it stays in place. The Gimbal is in free mode. Then I start the Slave remote and take control over the gimbal. As soon as I rotate the camera in any direction it jumps back in center position after 1 Second.
Any tipps? I don't know what I might have changed. And it worked fine the first months.
I hope and think that there is just one little button I'm too blind to find right now.
Kind regards
GoMe
|
|
