Possible fix.
I had all of the symptoms on here. Flashing green light on controller after firmware screw up and no connection between the drone or controller Couldn't get beyond the How To Connect page. I could fly it but no camera. I have an Advanced Phantom 3. I tried every fix on here. Nothing worked.
What eventually worked was doing the relink sequence in a different sequence. I put the controller in to RELINK. Only then did I turn on the drone.
Power on RC
- Press the C1 + C2 buttons on the back of the RC together and keep them both pressed;
- Press the video record button (on the left shoulder of the RC), and keep pressed as well;
- When it starts beeping release C1, C2 and the REC button, press the camera settings wheel (on the right shoulder of the RC);
- The linking mode is now activated: the RC shows a blue led and starts beeping;
At this point I turned on the drone and let it load and "settle". Then I pressed the link button.
- Press the link button on the aircraft within 1 minute (see the user manual for the location of the link button, its right beside a little red LED on the right side of the bird);
- When the RC shows a green led, and the beeping stops, the linking procedure has succeeded and the control link has been restored.
I got a solid green light on the controller within a few seconds.
If it doesn't work I'd just keep trying different sequences. But this worked for me.
|