Bruno28
lvl.1
Flight distance : 9337 ft
Australia
Offline
|
Donnie Stugots Posted at 2017-3-2 06:14
Can you raise the gear when flying with the "Automatic Landing Gear " enabled That would help eliminate the sensor as the problem . ( i realize you are getting data, just want to see if that translates into action on part of the retract gear ) If you can great , If you cant will it work if you just did it manually ?
Are we talking Inspire 1 or 2 as well ? If you are on the Inspire 1 please try an IMU update and then follow that IMMEDIATLY with a camera Gimbal Update, My thinking is if the AC is not recognizing the gimbal and still thinks it's attached therfore not enabling the travel mode to engage.
Donnie,
Ok so answering your questions.
1. I can lower and raise landing gear via the Remote Control switch.
I have automatic landing gear, but it never lowers when I am as close as 30cm from ground. It does raise when i take off, but does not lower when I am close to ground automatically, even though its enabled.
2. We are talking about Inspire 1 Pro with X5 camera.
I will have to try IMU even though I've done a check and its said that its not required.
3. What do you mean by "IMMEDIATELY with a camera gimbal update"? You mean a gimbal calibration? Software update?
The gimbal does fully work when flying so it must be recognising something?
4. Current firmware:
App: 3.1.3
Aircraft 1.9.1.30
Remote 1.7.60
5. Ive read all posts on this thread and others, still nothing that helped. I haven't done IMU update, hopefully that can solve.
6. Yes, when I remove its the camera with gimbal, they are one part. Isolation mount stays on AC, nor removed. |
|