Punchbuggy
First Officer
Flight distance : 483166 ft
Australia
Offline
|
JockC Posted at 2017-3-30 19:09
Thanks. Tried it but it's obviously not intended foe drones running production firmware. In the calibration section, it comes up with an error and wouldn't let me start a calibration, even if I wanted to (kept telling me to reboot the P4). Still calibrates fine on another PC running DJI Assist 2 V1.0.9
No, it should be good, as I upgraded and re-configured my P4P recently using v1.1.0-0.
Be advised that you had to install V1.1.0-0 with signed driver enforcement off to be able to install All drivers, and I installed v1.1.0-2 in the same way. I'm unclear whether Neville (above) installed it this way though.
Do this under Win 10 by holding down <Shift> when selecting Reboot, and following prompts to do a selective reboot (Option #7 will disable signed driver enforcement, I think). After installlation, just reboot and start Assistant 2.
Or you could just keep using v1.0.9... :-)
|
|