Hello all,

After updating to the latest firmware, I have had this issue during mid flight. The gimbal will go very shaky, gimbal overload warning will appear, and I have no control over the gimbal when it happened. And yes, I always put on my gimbal clamp on whenever I am not flying. You can check the video below:

https://photos.app.goo.gl/lw6iL53JRpEl4O2F2

Mine did the same thing. I sent it back and it was replaced at no charge.

Calibrate the gimbal, then try to fly the drone in an open area again, see if it still have this issue. Besides, have you tried to re-upgrade the firmware?

DJI Diana Posted at 2017-7-24 21:17
Calibrate the gimbal, then try to fly the drone in an open area again, see if it still have this issue. Besides, have you tried to re-upgrade the firmware?

I downgraded back to 1.030.800, working fine after that.

fans18d204c5 Posted at 2017-7-24 11:56
Mine did the same thing. I sent it back and it was replaced at no charge.

ah, that's good for you if you want refresh covers that