Can anybody help me. after flying the spark today, the gimbal went crazy. After that i landed the spark, turned everything off an again on. After that the footage remained a little bit shaky. (Look at the video) I downgraded the firmware, i have done a compass and imu calibration but it is stil shaky. Does anyone have an idea? i will travel next week to mauritius and i need my spark.....  

Hi
Take off your props and check the lugs that twist to hold the props in place are intact and not damaged?

Hi,

there is no damage :-(

Well, it unfortunately looks like a gimbal step motors issue. Any crash before the problem started?

No Crash Not Even a harder landing.

Not sure if your using the RC, but can you control the gimbal  pitch using the app or the RC wheel ?

Also when the AC is on, and you angle the body from side to side does the gimbal compensate for this movement and keep the lens somewhat  horizontal ?

It it moves might be just a glitch, have you  done a factory restore in the DJI Assistant 2 on the pc/mac

Done the Factory restore in dji Assistant 2. i can Control the gimbal pitch with the rc and everything looks normal but there some "micro " shakes in the footage.

Would the wind be the culprit?  It looks very windy in the video.  

This was also my first thought, but same issue inndoors.

Could you please upload a footage which with the "micro " shakes for better assistance?

I would say that the the third "axis" of your gimbal, the digital one, is not working well.
Have you tried to reset the firmware to the very first version?

it looks like a hardware issue  ....

I also saw this in one of my last flight videos,  I figured it was wind.  Now I gotta test it out indoors later tonight

Today i went flying in windy conditions and i have to say that today there was no more issue. I reseted everything, downgraded to first firmware and upgrade it again. In addition to that i changed all props.
Looks like i have been lucky.



Thank you guys for your help.