So I was think it would be a good idea if DJI could put up fault codes that us members might come accross using the Mavic.
Instead of wondering what we are up against, we can view a list of codes that tells us what is wrong with unit or controller.

This morning i experienced a code that came accross my RC after the new firmware update it read  " Stick EM12 " followed by  " RTH manual "

I shared this with DJI online support and they imediately wanted me to send the unit back to them with logs, for repair to the drone, i'm like what repair are you refferring to ?

I knew it was because of the new firmware, my drone works flawlessly except for the whole Horizontal tilt issue that i have accepted is not going away even if i were to send it back to them.

I performed a RC calibration which resolved this matter.

So though DJI Tech support is good, i would not take to heart that what they say is always correct, use some common sense.

Full list of messages are in the manual v1.2 page 58 / 59

Harbourside Posted at 2016-12-7 16:00
Full list of messages are in the manual v1.2 page 58 / 59

Great I had no idea they were there, maybe i should delete this thread then

I would keep it up, all good information for those that did not read the manual all the way to the end
I don't want to spoil it for you...lol

Harbourside Posted at 2016-12-7 22:00
Full list of messages are in the manual v1.2 page 58 / 59

There is no Manual 1.2, the current Version is 1.0, where did you get an updated Manual?

Ulf-F Posted at 2016-12-8 11:37
There is no Manual 1.2, the current Version is 1.0, where did you get an updated Manual?

From the downloads section on the main Mavic page at DJI.com.
Trust me its been there a while

Harbourside Posted at 2016-12-8 12:44
From the downloads section on the main Mavic page at DJI.com.
Trust me its been there a while

A while? Date is 2016-12-07

On my page its the 6th.
24hrs Is a long time in the drone world, so anything over that is a while...
Anyway glad you can confirm it exists....