Hello,
seems I broke my naza v2. I have emax qattro esc (4in1) wich has 4 signal wires and bec 5V (+ and - wires). I successfully calibrated each esc by connecting signal wire to T channel or receiver. After that I connected all 4 signal wires from esc to M1-M4 signal and at Motor test page nothing happens, naza wond spin motors. After I decided to connect also ONLY ground wire from esc bec and after that my naza seems become broken or something else. Now when I power on naza I see around 10-15 red/green light (red-green-red-green....) and then constant green. Atempting connectiong to PC wasn't successful. What I did wrong and how to make naza working agan?

After few hours I checked naza again and it start works again and nothing was changed. Still can't test motors but after arming all works fine.