similar to all mavics these days the wheel for camera tilt on the rc+ has way too much  deadband and we cannot tweak those settingsplus it has a very loose spring and its really a setp back from the remotes we had on the I2
yes you can make smoth controls when you haVe all thiS deadband and lots of smoothing but its impossible to follow a bit faster moving subject...then the the tilt is all over the place

its nice there is an expo setting (this got canceld on the mavics! why?) but it would be important to also fine tune the deadband by the user  that sits around the middle position
I can only repeat this again and again...the I3 should not be locked like a consumer drone...pros need to change all these settings
thanks for listening

Hi, fansba3b7009. Thank you for reaching out and sharing your experience. We'd like you to know that we appreciate your valuable suggestions. We will forward your concern to our related department. All significant suggestions will be implemented after the evaluation of our relevant team. For the latest updates please stay tuned to our DJI official website at ( www.dji.com ). Thank you for your understanding and support.

Expo settings are still available for Consumer drones. After DJI Fly is updated to v1.5.4, the DJI Fly app for Android, DJI Fly app for iOS, and built-in DJI Fly app in DJI RC Pro/DJI RC can adjust the remote controller EXP (supported by DJI Mini 3/Mini 3 Pro, DJI Mavic 3 Pro/DJI Mavic 3/Mavic 3 Classic, DJI Air 2S, DJI Mini 2, DJI Mini 2 SE, Mavic Air 2, DJI Mini SE, and Mavic Mini). Please refer to the figures below for the settings:

thanks for your time to help
expo is not what I am looking for and I know how to use it and I am thankful I can adjust this

what I mean is the software deadband around zero of the fingerwheel...the fingerwheeel is very loose by hardware and its not easy to controle it gently
and especially because the deadband is very hight by default its so hard to know when the gimbal starts to move
would be much better if I can lower the deadband-end