leungyuching1
lvl.1
Australia
Offline
|
Hi All,
I am having trouble enabling IOC for my Phantom 2.
I have installed the latest P2V Assistant software and updated the latest firmware v3.08 however I am unable to enable the IOC.
The following were done:
- Enabled Naza-M mode in Assistant Software
- Ensured all the sticks and switches movement from the remote are showing in the Assistant Software
- Checked "ticked" the IOC check box under Advanced > IOC
- I am able to see the highlighted HL, CL, None are changing according to my switch position on my remote
- Wait 5 to 10 seconds and power off P2 and remote
- Power on Remote , P2, Connect P2 to PC again however Assistant software states the IOC is not enabled.
Note:
- Assistant software is installed on Windows 7
- I am able to register the GPS / FailSafe feature on the remote with the Assistant Software.
- I am able to make change to the Gimbal, flight hight/distance setting with the Assistant Software.
- Assustant Software "Basic" view shows every single action from both joysticks, two sliver S1,S2 switch and the Gimbal switch at the back.
Has anyone got the same issue and what was the resolution please?
Regards,
|
|