fans0f495b20
lvl.1
Japan
Offline
|
Hey there,
I bought my drone last month.
I have always been very careful about checking if the camera was free of movement before each flight.
I had 1 crash (it got stuck in branches) during one of the earliest flights.
There was no problem until I tried using the Panorama option about a week ago: the "Gimbal motor overloaded" message started to appear (not always on, only intermittently) and the camera was doing this up-down movement (no right-left as I've read on other posts).
Since then, I always check if the firmware is updated, and I Auto-calibrate the gimbal before each flight, checking if the compass are normal.
Now the message sometimes appears, even if in normal camera mode (not in Panorama), even if I move the gimbal very slowly during the flight.
Is there anything that I can do? Should I repair/have it repaired?
Thanks for your help ^^
|
|