I'm flying a company’s drone for them, it is an Inspire 2 with X7 camera. Since taking over it, I have been plagued with issues. If it sits turned on for a small period of time (like when I am doing camera settings for a client so maybe 10 minutes of idle time), the drone starts to get issues like Accelerometer failed, gyroscope error, camera sensor error, Aircraft encoder error (0x1400000) etc. The landing gear also fails to work properly and then I have to physically move the gear a few mm to get them to start working correctly. Once I let the bird cool down, restart it, I have no issues, I can fly it and it works fine. When I am on set this is a huge issue. I have sent in to the DJI partner who does repairs on the island, but they can't see a problem at all. They downgraded all the firmware and it seemed to do the trick, but then for some reason I can't access PRORES RAW and PRORES RAW HQ. So I upgraded everything and now the issues have started again. Flight Controller Serial number is 095XF1800200WB VERSIONS: Aircraft 01.02.0300 Remote Controller 02.00.0190 Camera 01.09.22.22
|