MD101
New
United States
Offline
|
I'm very glad to share that this issue is finally behind me. Turned out the iPhone lightning port was loose and needed cleaning. I tried another iPhone which worked and made me think it's not a phone 6 issue after all.
For other newbies to P3 Pro, the following should get you started:
1) Use the SD card to apply the latest firmware on the drone. It took about 10 minutes. In my case, I have two batteries, so I did it for the 2nd battery too, which took under 1 minute to finish.
2) No need to do firmware on the RC.
3) Connect phone/tablet to RC. Turn on the RC, and turn on the drone. In the DJI GO app you should see lovely and green the "Aircraft Connected" as the image below. In the camera view you should see the image preview. That's where I'm for now.
Thanks to all who offered help! Donnie, your comment regarding the cable is very helpful indeed.
|
|