ross2266.gmail
New
United States
Offline
|
Jeep - Yes, I have checked the easily accessible ribbon connections and confirmed that they are intact. I even tried disconnecting a few of the ribbon points to see what would happen, and i have the same issue where is doesnt move and makes the same noise. This leads me to believe that it is not a ribbon issue.
That said, on the first flight the ribbon that wraps around the very bottom of the gimbal unit was struck and sustained some denting (see photos).
The gimbal did not separate when it hit the ground and there were no obvious hardware breakage afterwards, however, I initially had a gimbal issue similar to the other gimbal issues that most people are posting about (where it shakes violently when turned on), but after taking everything apart and putting it back together it worked again.
I had several successful flights with no issues after the first minor crash, so i dont think that this particular issue is related to the minor ribbon damage, but I guess i might as well replace the ribbon as a precautionary measure.
|
-
bottom ribbon rock damage
-
bottom ribbon rock damage
|