DJI Mindy
Administrator
Offline
|
Cian Ryan Posted at 2017-1-8 14:37
Yea, I already did a downgrade yesterday, nothing helped, it was just as bad, so I went back up. I did notice that just before the gimbal overloads, the tilt axis reach about 50-60 degrees Celcius wish is about 130 degrees fahrenheit. The tilt axis is kind stiff compared to the other axis motors, Im not sure if that was there by manufacturing, but I doubt its a physical problem, because other people are experiencing the exact same thing!
-Cian
Hello Cian, if gimbal temperatures gets too high, it might caused the motor overload.
Please try to cool down the aircraft and test again.
If still no improvement, I'd suggest you to send it in for further evaluation. |
|