fanse3b0cb7a
lvl.1
Flight distance : 458832 ft
United States
Offline
|
I have been unable to locate any information on this issue. Would love some outside thoughts on this.
I picked up my inspire 2 yesterday evening and started charging up everything. This morning I started with my initial setup. My iphones, iPad mini, and iPad Pro, will not connect to the RC. I have followed all procedures as shown in manuals, videos, and these forums etc. This step should be simple, but my devices will ding and cycle to a "Not Charging" in the top right hand corner of the apple devices two times and give up. Same results on all my devices. I have attempted different USB cables (original and new), updated the drone firmware, reinstalled the GO app multiple times with device restarts all over, and nothing gets me any closer.
I'm not sure if I have a firmware conflict, but since the inspire 2 requires the Go app for firmware updates to the RC,and I can't get my RC to connect to my device, I'm a bit stuck.
Thoughts? Similar issues?
|
|