i bought a Inspire X5R and all installations are Done. Inclusive new FW update..
So i still have one issue with the control of gimbal with my slave controller.
I clicked on "Control Gimbal" and confirmed on the master controller. Then I have access to the gimbal.
In the remote control settings, I can define the directions, but the gimbal does not move.
Please take a look to my video:
If i turn the slave Controller on, it make *peep* two times. is tha correct?
1- Do you have the Master camera control camera set to the FPV mode ? Make sure it is set to the "FOLLOW"
2- Next go the Gimbal settings ( configuration1- 2-3 is under the Advanced tab ) and make sure none are set to to low a value , ( gimbal Pitch- Yaw ) the Camera will not move if the value is set to ZERO or barley move if below say a setting of FIVE , for testing I would write down the current settings and then "Reset" them and re test , you may have the settings set to low .
The last thing to check is that you dont have the Master RC set to "Coach Mode " do you ? If so be sure to disable it . ( this option is on "remote control settings of go app ). coach mode allows full contrtol of the Ac from the Slae Remote .
I think the problem is one of the above .
Dont swap the Master to the Slave till you try this .
You vido does not give alot of ionformation but I think I know what you are referring to .
1- Do you have the Master camera control camera set to the FPV mode ? Make sure it is set to the "FOLLOW"
not sure if this helps anyone, but I was having a similar issue where my slave remote wasn't panning the camera, only tilting. I noticed in the app that the camera was set to FPV and not FOLLOW. After changing, the camera worked again