Since I set up the fixed wing mode on a Mavic with software 01.03.0900 I can no longer program the C1 and C2 on my remote. Is there a way to disable the Fixed wing mode so that I can use the C1 and C2 buttons again to program the buttons for other uses?

I believe you can change it back in the aircraft settings. Click the "..." on the right upper corner, select Remote Controller Settings and scroll down and you will see Button Customization option.

Did you have any luck with this issue?? I'm having the same problem

You disable Fixed Wing Mode in the same place where you enabled it.
Watch this:

Tried that but as soon as I hit the disable button where I turned it on it automatically turns itself back on and I can't customise c1 or c2 anymore

Marleydawg Posted at 2017-8-25 00:34
Tried that but as soon as I hit the disable button where I turned it on it automatically turns itself back on and I can't customise c1 or c2 anymore

When flying your Mavic in Fixed Wing Mode and then pushing the right stick down for a couple of seconds, will your Mavic exit Fixed Wing Mode?

Yeah it stops flying in fixed wing mode but is still enabled and asks me to push c1 to engage constantly

And can't turn in off In settings

Removing DJI Go and settings and rebooting then installing it again on iOS resets all the preferences for the flight modes. Did you try it?

No I hadn't tried that! And it has worked thank you so much!

Glad it worked. Just remember to check you RTH settings, as they were probably reseted as well