I am having some difficulty finding both sides of the factory landing gear for the newer Vision +.  I have seen several Amazon ads for the side with the anti-static compass (part# 18), but did not have the other side.  It was over $6. shipping for the one side.

Can anyone point me to a dealer who would likely have both sides of the gear available? Just trying to gain that extra 1/2 or 3/4 inch ground clearance over the stock gear for my Phantom 2 v2, non-vision aircraft with the H3-3D and GoPro.

Like these?

Guess not see next post.

No, not the right ones.  The Vision+ legs are longer. About 1/2 or 3/4 inch longer, or should I say higher

these stock ones - scroll down the page a bit

Are they the right ones?

Thanks, I believe those are exactly what I am looking for.  Both in one place, wonderful!

Parts ordered.  Thanks again

GMacD....I have been told in a previous discussion on this site that they can be put on the non-vision.  I'm not clear on the height difference but it has been estimated at 1/2 or 3/4 inch.  I will try to remember to let you know.  Perhaps I will post an image on a new thread to show the difference.  Perhaps a before and after set of images. I think the Phantom shells for the both of them are identical.

oakspi Posted at 2015-3-22 07:38
Parts ordered.  Thanks again

My pleasure.  I do hope they are what you want.

I just put them on my P2 h3-2d non-vision, not the compass though. They are about 1/2" taller.

For anyone else looking, these parts can be found on Amazon too.

Vision Anti-Static Compass: http://www.amazon.com/gp/product ... Id=KBLMNBTVGO54M4BA
Vision Landing Gear: http://www.amazon.com/gp/product ... Id=GJSMVDZCSJBR275T

Vision+ Anti-Static Compass: http://www.amazon.com/gp/product ... Id=WKC3Q26YI33NL3GI
Vision+ Landing Gear: http://www.amazon.com/gp/product ... Id=YZ3VDKOZ4LAGJUPE

And, here's what to do if your Vision compass cable is too short:
http://www.phantompilots.com/vie ... mp;p=331239#p331237

Thanks Mike.  I have the newer Phantom with the anti-static compass now so the mod should go without any short cable issues

Phantom2Flyer Posted at 2015-3-23 13:41
I just put them on my P2 h3-2d non-vision, not the compass though. They are about 1/2" taller.

If I understand you correctly, You bought a set of Vision Plus legs and put them on.  But not the Vision Plus leg with the anti-static compass.  From what I have seen posted, you could open the new anti-static compass cover and plug in the older unshielded wire plug.

oakspi Posted at 2015-3-23 21:31
If I understand you correctly, You bought a set of Vision Plus legs and put them on.  But not the  ...

Yes, exactly. A set of vision+ legs without any compass. I refitted my original compass in the usual location.
I could upgrade to the new compass and as you say fit the old wire to it but I haven't done so yet.

I received my new Phantom Vision Plus landing gear today.  They are taller than the non-vision gear.  I will take some images and post the before and after tomorrow. Looks like a trouble-free mod.