Maybe this has been covered.  I think I am having firmware problem, my p3s will not hover in one spot, it moves side to side and front to back. Also my camera is slightly tilted to the left. Could this be a fw problem?  I have calibrated the cumbal and the imu. Still flied erratic. The dji go apps says I have the latest update.  Also I have no map.

hmmmm..... tricky issue.  first thought, has home point been set? Are all devices 100% charged. Most of all has aircraft and controller been through all calibrations?

Home point set, everything charged and all calibrations done, rc and ac.

Also noticed today when I landed the quad, I let it run idle a few seconds and the quad tried to roll over to the left.

fans64143ce6 Posted at 2017-8-10 19:21
Also noticed today when I landed the quad, I let it run idle a few seconds and the quad tried to roll over to the left.

Aloha fans64,

     Have you checked for magnetic interference?  Also, is there any interference from running fans or electrical wires?  What type of environment are you flying in?

Aloha and Drone On!

I would recommend you calibrate RC sticks first to check whether it helps.

I've already calibrated everything that can be calibrated, and yes, I calibrated the RC first Susan,

fans64143ce6 Posted at 2017-8-12 10:18
I've already calibrated everything that can be calibrated, and yes, I calibrated the RC first Susan,

Is the RC calibration successful or not? If yes, please PM me your DJI account and upload the flight record, I'd like to look into it.