Hello, was recalibrating remote today on my Phantom 3 pro and noticed the right stick binding slightly.  After further inspection, I noticed the black area surrounding the stick was slightly pressed in below the surrounding shell. Pulling the stick brings this area out with a slight clickbut with little pressure on the stick it falls in again.  I'd hate for it to bind while flying. Has anyone had this issue before?  Not many flights on this machine, disappointed.

Never heard of that happening.  Sounds like a defect.

I'm with Alabama.......sounds like a manufacturing defect.  Contact DJI and I'm sure they will make it right...and I'm assuming from what you said it's still under warranty.

Had you reported this case to the support team? Could you please provide a short video for this case to support.us@dji.com for a further help. Thank you.

Thank you all, will send a short video to that email.

Sent a video to the email but it won't upload here.  Here is two pics. Look at gap between black and white areas.  

Sorry, posted same pic.  

If it is out of warranty, I would take it apart to investigate what is going on. It only takes a few minutes to remove a couple screws and pop the two halves apart. It may be something broken inside that you can repair with some epoxy or choose to replace if necessary. Or it could be a screw loose ? It is not hard to take apart.