Hey, I'm getting confused what is the real sequence to turn and connect the drone. Can help me?

- App DJI GO turn
- USB cable RC to smartphone
- Turn RC
- Turn AC

Is this correct to get connect right the AC?

Are you asking?
-Launch the DJI GO App - Open it
then
- connect the USB cable to the RC & smartphone
Then
- Turn On the RC
then
- Turn on the AC
Yes that sounds OK to me and is similar to how I do mine.  The manual does recommend a sequence but it is not clear, can be found on pg 57

Ok thanks . Sonetimes i was open the app after turning the RC

Here's how I do it with my P3P:

Make sure cable is not connected to mobile device

Turn on controller

Turn on mobile device

Turn on AC

Wait.

After mobile device has booted up and I have swiped the screen and "logged on"...

Plug cable into usb port of mobile device (I use Android) (other end is already plugged into controller).

I get a pop up that asks me how or with what app do I want to use the usb port?  One of the options is Go so I touch that.

Once or Every time?  I choose Once

Then I bring up the Go App

I'm all set.

I'm sure there will be others who will have different opinions.  

That sounds good, the most important thing about that is the arc must be powered up before the aircraft.  

Yes, this is automatic in my mind, at least hehe

Mark The Droner Posted at 2017-9-23 11:42
Here's how I do it with my P3P:

Make sure cable is not connected to mobile device

I follow Mark's procedure too. Never had an issue.

Remember when turning off.
Opposite
Turn off AC
Turn off RC
Turn off App

Yeah, thanks

I almost do the opposite.

1. Turns the tablet on and connects the RC USB port to my tablets USB port.
2. Turns on RadioController.
3. Turns on Mavic or Phantom.

and then DJIGO4 pops up and asks to use the USB plug on my Android tablet, which I naturally allow.

In fact, it does not matter if DJIGO4 has started up or it crashing as it is your RC you control the aircraft with.

Fly safe, regards Leif.

I tried as same of you Landbo, but my app pop up right when I open it after turning on the RC and AC.