I can't see the wifi channel to change the frequency on my android tablet because it's all squished together, anybody else have this problem??

Did you use OTG cable? It will make the image of wifi channel disappear. Can you provide a screenshot of the situation for better analysis? Thanks.

DJI Elektra Posted at 2017-10-11 19:18
Did you use OTG cable? It will make the image of wifi channel disappear. Can you provide a screenshot of the situation for better analysis? Thanks.

No i don't use a OTG cable as it is my understanding that such a cable voids the warranty.

Reboot the drone and RC - if still the same I'd suggest deleting and reinstalling the app on your device and possibly refresh the FW.

reebot not helping?

Lightning7 Posted at 2017-10-13 11:36
No i don't use a OTG cable as it is my understanding that such a cable voids the warranty.

Could you connect the wifi successfully? From your picture, there was no image. Any error message from your app?
Please watch the following video and try to reset the wifi. Keep us updated, thanks.

I have done all them reset reflashed  and  no don't see an error message in my photo i posted?

I think its the table.

On my samsung galaxy s5 i see it but not the android tablet.

Do you use Android version 7.1.1? Try to see if with Android 6.0.1 everything works fine, it might be this. I mean the APP DJI GO 4 could have problems with Android 7.

Lightning7, please follow the advice of MaxBDS. You can also change a mobile device to check if it is caused by phone.

MaxBDS Posted at 2017-10-15 01:22
Do you use Android version 7.1.1? Try to see if with Android 6.0.1 everything works fine, it might be this. I mean the APP DJI GO 4 could have problems with Android 7.

Am using a Insignia NS-P10A6100 Android version 5.01 and there are no updates for it.