Yikes, changed wire harness after crash and now cannot get gimble to power..opened craft...rechecked all wire connections...rechecked wire connections to gimbal...did I miss anything...any thing else before I find and expert to send it to. Thanks, Don

Do you have a voltmeter?
Is that how you checked the connections?
Or did you just do a visual?

just a visual. do have a voltmeter but do not know what I am doing...maybe better to reassemble and send in to an expert...tried so hard to see if I could not fix myself but have been at it for a month...am new to RC UAV/small electronics...learning lots...can control quad well, am ready to make photos and videos...I must have a disconnect somewhere....re connected all 2X...maybe having previously wrongly connected ESC to MC...maybe I did damage. Over my head. Thanks for respond. Don

Hi Don,
In your case,it is suggested to ask for dealer and send it back for maintenance to our repair center if you still can not fix it.
And here is our repair service info. : http://www.dji.com/support

Understood. Will do. Thanks ALL. Don