I am getting an error that read " no image transmission". It was working fine on last flight. The system test says that the gamble is disconnected.... what can I do?

I get the same thing but my gimbal is also having a fit

Post a video here, someone may be able to help.

Hi there, for this issue, please try to restart the drone for several times, remove the SD card and check make sure the firmware is up to date. If the issue persists, please help to confirm if the drone has crashed or impact damage to the gimbal before, send it back for repair if necessary. https://repair.dji.com/en/SelfRepair/Area

Pulled the sad card out and put it back in..... works perfectly!

Now I have a different issue.... I updated my firmware and sport mode isn't working.... my drone that used to go 60 km/h only goes 12km/h..... wtf?

When I switch to sport mode i get a message that it can't be done and has to be done from the main controller.... Anyone have any ideas on how to fix this... and I can only go about 100ft away and the drone stops????

Dinomite34 Posted at 2017-12-3 09:32
When I switch to sport mode i get a message that it can't be done and has to be done from the main controller.... Anyone have any ideas on how to fix this... and I can only go about 100ft away and the drone stops????

There is a toggle switch in the DJI Go app that activates the sport mode. Touch this to allow sport mode to be used.

DJI Thor Posted at 2017-12-1 00:05
Hi there, for this issue, please try to restart the drone for several times, remove the SD card and check make sure the firmware is up to date. If the issue persists, please help to confirm if the drone has crashed or impact damage to the gimbal before, send it back for repair if necessary. https://repair.dji.com/en/SelfRepair/Area

Hi , i tried all of what you mentioned and the gimble is still disconnected.

Flashman75 Posted at 2017-12-27 01:20
Hi , i tried all of what you mentioned and the gimble is still disconnected.

Does the gimble respond to a calibration request ?

Flashman75 Posted at 2017-12-27 01:20
Hi , i tried all of what you mentioned and the gimble is still disconnected.

Sorry for that, please send it in and we will help to take care of it. If you are in Australia, you can contact suppor@dji.com for a further help for the repair process.