my phantom vision 2+ is camera is not working after changing gimbal ribbon cable. please help to solve to problem.
thanks in advance

Double check your ribbon cable, make sure it is squarely and firmly seated in each location with the black retaining clips on the opposite side securely in place.  I recently had this issue after a repair only to take it back apart a few days later to find one of the connections not securely in place.

busclas Posted at 2015-4-21 22:15
Double check your ribbon cable, make sure it is squarely and firmly seated in each location with the ...

thanks for your advice, i have double checked its fine.

Check all three plugs at the gimbal also. Make sure the are plugged in tight and are in all the way.

roy@mcscomputer Posted at 2015-6-26 18:26
Check all three plugs at the gimbal also. Make sure the are plugged in tight and are in all the way.

thanks for your advice. everything ok. but now after adding extra antenna for wifi i didn't get GPS Signal properly. even  one satellite signal is not showing in the dji software. what to do.. will you advice me.

thanks in advance