Hello. After switching on the quadrocopter, image and sensors are not displayed for a long time. No errors are displayed, only the memory card slot is blinking. Only after a few minutes there is an image and sensors are turned on, in places where the temperature is below room temperature - wait for the appearance of the image and the inclusion of the sensors on the screen for more than ten minutes..

Hi there, may I know what's the color and status of the backward LEDs? Generally, it takes some time for the drone to warm up in low temperature. Alternatively, you can test this in room temperature to verify. If still no luck, please kindly upload a short video for further assistance, thanks!

I updated the application and the whole error now appeared error: aircraft encoder error 0x20, has appeared to the whole problem, which disappears after several minutes after the start of the copter, As soon as the error disappears, an image immediately appears . The color of the indicators at this moment is red - orange - green. Yesterday I went out into the street (-10 Celsius), and there this error did not disappear within 15 minutes, but at the same time the error disappears in a few minutes.

Mine does the exact same thing among other issues, quite annoying using 6-10% battery before image appear in app

KedDK Posted at 2018-1-26 00:06
Mine does the exact same thing among other issues, quite annoying using 6-10% battery before image appear in app

[view_image]

Do you also have a low temperature camera and sensors loaded for longer than usual?

fans5b2b4538 Posted at 2018-1-26 05:57
Do you also have a low temperature camera and sensors loaded for longer than usual?

Not sure i understand fully, but it hangs with that #Aircraft error for 5-10 min, then i goes away and the picture begin to appear on the App.
I have not seen any "low temperature camera" error, but issue is there also inside, perhaps it takes a little longer outside.

uppppp topic

upppppppppppppp

I think the ony solution is to return it to DJI.
Did the latest upgrade of AC and +RC today, now the is no notification of "Abnormal" firmware status and no "Aircraft encoder error", but still same black screen for several minutes.
Took it out in aprox -2c and even it was warm already, no image for more than 10 minutes.