This morning I sent my mavic straight up for a few quick shots of the sunrise.
Near the end of the drone's startup sequence, I heard a whirring noise that I had never heard before.  That troubled me a bit.
Once the drone was up I noticed this odd banding on the screen - never had seen that before.
It seemed to disappear when I took a 360 Pano shot, but when pointed right at the sun it would return.
I checked the images themselves and there was no banding effect.

Prior to this morning, I flew my mavic for about 5 minutes the evening before in what was an uneventful flight (just a very short Point of Interest video). No crashes, no issues, and no strange whirring sound.



Has anyone seen this before?
I'll check the logs when I get back home.

I just experienced this a week ago. Over exposed warning ⚠️ is on. Check your settings.

Woe Posted at 2018-1-23 09:42
I just experienced this a week ago. Over exposed warning ⚠️ is on. Check your settings.

Ah thank you.
I did just enable that last night. Might explain a few things.

lot.wendigo Posted at 2018-1-23 10:03
Ah thank you.
I did just enable that last night. Might explain a few things.

No problem.

May I know what's the current status? Has the issue been figured out? Feel free to contact us if there is any further question.

It's the zebra lines advising you that this part of your image is over exposed - I switch it off and prefer to use the histogram