Hi

I have seen various threads for the Mavic Pro about removing the rubbers from the remote control to allow a phone with a case to fit. The Mavic Pro remote has 3 torx screws to facilitate the removal of the rubber bungs.

On the Air remote, these screws are not present and I can see no mechanism to remove the bungs.

Anyone know how to remove the bungs - preferably without destroying them?

Fed up with removing my phone from its case each time I fly!

Additionally, does anyone know if the mavic pro power/charging connector is the same as that on the mavic air?

Nigel

Bit bodgy but the RC will sit on the inside cover of my iPhone SE folio style case: