CDMSystemsLLC
lvl.2
Flight distance : 1766572 ft
United States
Offline
|
I've been banging my head against a wall for a while now on this issue. Here's the setup on my rig:
M600 Pro
Ronin-MX Gimbal
Sony A7Rii
RUNCAM FPV Flight Cam
Dual Pilot with Master / Slave RCs
Crystal Sky Dispalys
ALL FIRMWARE UPDATED
Upon initial power up both remotes come online as expected. I set the MASTER to view the RUNCAM via "HDMI / AV" selection under HD settings. I set the SLAVE to the Sony via "HDMI/AV" selection under HD settings. Got great video on both displays. Within only a few minutes on the ground, the slave video display goes gray and the video no longer updates. I can still control the gimbal but nothing on video. I can swap back to my RUNCAM on the slave and then back to HDMI and I'll get the image transmission again but only for a few mins and then it goes gray (by going gray... the last image is still there like it froze but all color is removed). According to DJI, the gimbal / camera shutter control runs between master and slave RCs but the video transmission is from the M600. I cannot for the life of me figure out what's going on or why. I've heard of people having this issue with the Inspire 2 but my I2 has never even had an issue like this... but this M600... ready to shoot it.
I've reset both RCs... relinked the master... nothing seems to fix it. I've played with the percentages HDMI / AV... none seem to fix this.
Can DJI offer a solution to this? From what I've read it's an issue that's been going on for a while.
THanks,
-Andy
|
|