[size=14.6667px]Hi, I have a big issue with the yaw motor.
[size=14.6667px]While panning continuously, the motor makes a short stop and then continues to pan.
[size=14.6667px]It doesn't happen when panning with the ipad, using touch.
[size=14.6667px]I put yaw on another stick, same error.
[size=14.6667px]Same error while panning with master Remote. I althoug have changed cendence to slave.
[size=14.6667px]Setup: i2, x5s, latest firmware (april2018), cendence master, stock remote as slave.
[size=14.6667px]

[size=14.6667px]The only way it works smooth if the Inspire has no GPS fix



[size=14.6667px]Anyone experienced this?


[size=14.6667px]

Sorry to read on this, did you try to calibrate the gimbal? Or reset gimbal in Advanced Gimbal Settings? Does it happen when you got it or any hard landing or firmware upgrade?

Sure, did a reset and calibration.

And it works normal if i use the ipad to yaw and if the inspire has no gps fix!

wingthing Posted at 2018-4-27 01:12
Sure, did a reset and calibration.

And it works normal if i use the ipad to yaw and if the inspire has no gps fix!

That is weird, it should have nothing to do with the GPS, may I know if you run the latest firmware? Have you tried to calibrate the RC?

Latest firmware, tried candence and regual remote as master. although have used another stick.

wingthing Posted at 2018-4-27 01:34
Latest firmware, tried candence and regual remote as master. although have used another stick.

Thanks for the clarification, the issue has been forwarded to our engineers for analysis, I will come back to you soon once I hear from them, please wait patiently. Thank you.