So.. do I need a yet to be released DJI firmware update to wirelessly bind the new Phantom 4 Pro version 2.0 using Ocusync to the DJI Googles? Both Aircraft, Transmitter and Goggles are on latest FW release as of May 15th, 2018..
Hmmm. I have both the Racing edition and the original goggles.. neither will bind on latest firmware.. and following same binding procedure that was in place for Mavic Pro
The Phantom 4 Pro V2.0 only supports the DJI Goggles RE only after the DJI Goggles RE's firmware is updated to the latest official version.
The Phantom 4 Pro V2.0 will support the DJI Goggles after the DJI Goggles' firmware is updated to the latest version. The latest firmware version is under testing, appreciate your patience.
DJI Mindy Posted at 2018-5-20 00:42
The Phantom 4 Pro V2.0 only supports the DJI Goggles RE only after the DJI Goggles RE's firmware is updated to the latest official version.
The Phantom 4 Pro V2.0 will support the DJI Goggles after the DJI Goggles' firmware is updated to the latest version. The latest firmware version is under testing, appreciate your patience.
Any news on the new firmware update for the DJI goggles?
I have my P4Pv2.0 and RE goggles working great! There are no clear directions I could find to let you know the light above the SD card slot is the binding button. Hold it in for a few seconds until it blinks red then the RE goggles will bind.
I worked great right out of the box. First flight with them today. Outstanding.
I ordered the RE goggles with the drone direct from DJI, and I did update firmware as part of setup.