I have a Z15 that I just put on my S1000. I'm using a A2 controller with a Lightbridge 1 and a Sony Nex5n camera. I have the mode set up on a 3 position switch that if I run the Z15 assistant is switching to the 3 positions. It works on the mode where the camera points in the same direction irregardless of the S1000 orientation which I guess is H.free. If I switch it to H.trace the gimbal starts buzzing and slowly rotating and is unresponsive. I have the shutter, tilt and pan all working just not the mode switch. Any ideas I'm at a loss.

This sure is an active forum