I recently installed the naza m v2.
I am using a readytosky s500 frame
emax 935 kv 2213 motors
1045 props
30 amp escs
Venom 3s 5100mah battery
The weight of the drone is approximately 3 pounds.

The drone takes off, hovers, then as soon as I move in any direction, the drone oscillates wildly, loses control, and crashes to the ground. I've tried basic and advanced calibration of the IMU, and I tried setting the basic pitch and roll gains with the remote. Is thre anything else that I could do to possibly correct this problem?
Thanks

So i took the drone out again today to play wth the gain settings again. Does this behavior look like too much or too little gain? I had the gain between 130 and 220 for pitch and roll throughout these flights.