Hi,

is there a recommendation from DJI where to put the license plate (required by German law) best on the Mavic 2 Pro / Zoom in order to not cause interference?

There is this old post from January 2018 that describes it for the older models, but I'm not sure whether this is applicable to the Mavic 2 series, too?
https://forum.dji.com/thread-132308-1-1.html

Regards,
Arne

I believe it to be still valid and plan to put it in the middle of the back between the two sensors.

Hi there, thank you for reaching DJI forum. I will coordinate with our R&D engineers regarding this concern and provide  you the answer as soon as possible. Thanks for your support.

Any updates on this one?

Wachtberger Posted at 2018-8-30 01:30
I believe it to be still valid and plan to put it in the middle of the back between the two sensors.

Exactly where I put it. No probs whatsoever. In Germany you are forced to put it onto a visible location.

EMBE Posted at 2018-10-18 02:36
Exactly where I put it. No probs whatsoever. In Germany you are forced to put it onto a visible location.

DJI has recently recommended another good option to which I might move it. But so far I did not experience any problems on the back side either: https://forum.dji.com/thread-132308-1-1.html