Is this CE mode?

Also i´m wondering why there are no bars to see (it has allways been like that), i don´t use OTG.

Regards.

No mode
But seriously, try using an OTG cable or restart ALL the equipment.
You need to be able to see the channels.
If you see from 1 to 11 you are in FCC.
If you see from 1 to 13 you are in CE.

Fly safe.
Alex.

It flies though, i tried with the OTG cable, but it does´nt work (i tried many times). The bars have allways been like that, from when i bought it.

What do you mean by "restarting all the equipment?

Regards.

It´s odd, the WIFI is connected, and everything works (short range though) but no bars, maybe it´s something with phone, huawei p8 lite.

Regards.

I have the same "problem". Since flying works and range and video lag is good, I don't care

Cheers,
Wolferl

try to reset your wifi and connect again, see minute 2.50

Thanks, i will  try to reset it again.

Regards.

Just tried, when i press the RC connection button it brings me to the log-in, i try to log in, but can´t  because it says "no internet connection" even if there is.

I tried again, and when i press the RC connection it brings me to the flight list, and nothing with WiFi at all.

first reset, then link to rc

Thank you very much for helping out, i will give it a go again tomorrow I´m am tired of fiddling with it today.

I also bought the activation code for the  dji go mod from nolimitdronez  app last night, to see if there is anything i can do to improve the WiFi, unfortunately the code had disappeard  from my email this morning when i was going to use it, i did contact them, so now i´m waiting for a new activating code.

Regards.

I got the activation code but can´t figure out how to activate it.

Regards.

I found out how to activate it,  but the mod is too complicated for me, so until further i won´t be using it.

thats a shame, you can ask for support here: https://dji-rev.slack.com/
just make an acount and add the NLD channel, they will  help you.check your PM

Thanks for the tip, i might do that some time, but i´m tired of fiddling around with this thing for the time being.

I´m just too old for all this tech stuff, i´m sure a 12 year old kid would have figured it all out in 10 minuttes.

Regards.

check your PM messages

Thanks a lot Jos, i will give it a go later.

Regards.

your welcome

Hi, Sorry for the inconvenience. I would like to ask if you manage to reset the wi-fi of your Spark? I would recommend restoring factory default and refresh the firmware using the DJI Assistant 2 to see if there will be changes. Please see the link below. Thank you for the support.

https://www.dji.com/spark/info#downloads

Thank you for the advice, i will look into it.

Regards.

I did the reset thing, and tried to connect the  spark directly to the phone,  and i did get the  Wi-Fi bars in the dji go app, then i connected to the RC, and the bars were gone again, i´m sure this thing is cursed.

I wished i could use the OTG cable, but unfortunately it does´nt work.

Regards.

Maybe it has got something to do with phone which has 2,4Ghz, whereas the dji go app is on 5,8Ghz, and i can´t change any of them.

Regards.