Hey all, I've suddenly become brain dead after stripping the bird down whilst testing av outputs and workarounds for the many who have no Ribbon cable.

My bird is a Phantom 2 vision +  with a P330CB-H3-2D V2   M1  board.  Naza plug that really matters

Any way, I've taken pictures of the wiring, but cant make out the M1,M2,M3,M4  Naza plug on my vision +.
If someone could check or upload a photo it would be great.....   is it TOP, MIDDLE, or BOTTOM that the plug goes into?
I think its middle but the pic looks like bottom......

Tried looking online but after 6 hrs of testing wires and trying the AV output / input as per the instructions for Lightbridge connection
I've seriously gone braindead.....

I have so many conflicting wiring schematics around me Im totally lost.

Ive used a picture from the net, the green box is what im questioning.......

Awaiting your input in anticipation....

Regards
Mix

No replies....  not one person knows or can look inside the phantom vision +
I expect that from DJI as they don't want you to know how to circumvent their equipment....

See here:


Top is      -5Volt
Middle is  +5Volt
Bottom is  digital Signal

Use the Bottom

I believe he asked for M1 to M4 connector, here is a picture, yes, bottom is correct though.

DJI-JS Posted at 2014-11-7 07:36
I believe he asked for M1 to M4 connector, here is a picture, yes, bottom is correct though.

Nice and THANKYOU.......

Bottom it is, was so sure it was middle set/row....    but my pic is more towards the bottom...   
Should trust my instincts...

Many thanks DJI-JS  I can power on and test now.......

mixstreme Posted at 2014-11-7 09:20
Nice and THANKYOU.......

Bottom it is, was so sure it was middle set/row....    but my pic is mor ...

No problem, and make sure you plug it the right way as the picture showed, red wire on right when you facing to the Naza.

DJI-JS Posted at 2014-11-8 07:46
No problem, and make sure you plug it the right way as the picture showed, red wire on right when  ...

Tested and working..  Thanks again DJI-JS and dieterste36 for your input.....

mixstreme Posted at 2014-11-8 12:10
Tested and working..  Thanks again DJI-JS and dieterste36 for your input.....

You are welcome, happy flying~